Uploaded January 2017 | Updated November 2026, 3 hours ago
Added small heated bed and tweaked calibration. Test with a few increasingly complicated parts. Final test print of detailed Yoda face.
End sections covers a test of the stepper driver I thought was damaged using an Arduino Nano, a 7805 regulator and a breadboard. I followed this guy's howto:
Watch?v=5CmjB4WF5XA&t=287s
Added small heated bed and tweaked calibration. Test with a few increasingly complicated parts. Final test print of detailed Yoda face.
End sections covers a test of the stepper driver I thought was damaged using an Arduino Nano, a 7805 regulator and a breadboard. I followed this guy's howto:
Watch?v=5CmjB4WF5XA&t=287s










