Uploaded April 2020 | Updated November 2026, 4 days ago
Welcome back folks, I truly hope you are are safe and well in these troubling times.
I wasn't going to uplad a video this week as the project is not finished - but after editing (not a lot else to do), i thought i would upload the video in two parts.
So here is the first part.
it includes turning a really warpped piece of Hornbeam that i wrestled into flat, marked it out and then start carving.
With regards to the Carving, my channel has recently joined forces with Dremel, whom are supporting me for the next 12 months.
The products that I have used so far are below.
Dremel
dremeleurope.com/gb/en
Dremel Fortiflex (9100-21)
dremeleurope.com/gb/en/dremel%C2%AEfortiflex-397-ocs-p
Engraving Cutter 1.6mm (106)
dremeleurope.com/gb/en/engravingcutter1-6mm-105-ocs-p/?start=0&
If you would like to keep upto date with what i am working on, please follow me on instagram - Link below
instagram.com/mgmakes
Part 2, will be up next week
Take care and Stay safe.
Welcome back folks, I truly hope you are are safe and well in these troubling times.
I wasn't going to uplad a video this week as the project is not finished - but after editing (not a lot else to do), i thought i would upload the video in two parts.
So here is the first part.
it includes turning a really warpped piece of Hornbeam that i wrestled into flat, marked it out and then start carving.
With regards to the Carving, my channel has recently joined forces with Dremel, whom are supporting me for the next 12 months.
The products that I have used so far are below.
Dremel
dremeleurope.com/gb/en
Dremel Fortiflex (9100-21)
dremeleurope.com/gb/en/dremel%C2%AEfortiflex-397-ocs-p
Engraving Cutter 1.6mm (106)
dremeleurope.com/gb/en/engravingcutter1-6mm-105-ocs-p/?start=0&
If you would like to keep upto date with what i am working on, please follow me on instagram - Link below
instagram.com/mgmakes
Part 2, will be up next week
Take care and Stay safe.










