Why not use a drill press? @FireballTool
Why not use a drill press?  @FireballTool
Uploaded July 2026 | Updated November 2026, 6 days ago
Someone commented to use a drill press for small parts. Fair. But when a contractor brings in posts drilled to the wrong bolt pattern, and they're too tall for the press and awkward in the mill? What do you do next?

The Fireball sidekick vise comes to the rescue. Clamps the part square in seconds, and a mag drill with an annular cutter takes from there. Boom! Just like that, your part is fixed. This sidekick vise is also more than just a vise for any other job. And it belongs in your shop.

Find the Fireball Tool sidekick vise only at Fireballtool.com

#fireballtool #tools #fabrication #welding #vise #drill #hacks #metal #siegmund #wilton #metalworking
Why not use a drill press?I Test the New 3M Cubitron 3 Flap DiscWill this 1000-pound welding table tip over?What Is The Best Bench Vise? - Reed 208 vs 614 HardtailHow To Make A Handrail Not Boring!How strong are these vise jaws?How I Built Sliding Doors for My Starship Office (2 of 9)Sway Bar Bracket LifehackThe Building Of A Starmap!Flipping the Switch on 500 Feet of LEDs. Starshiip office build!Youre adjusting that vise wrong! Part 1Fixturing Made This Process So Much Easier!
Fireball Tool |

Why not use a drill press?

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER