Uploaded November 2019 | Updated November 2026, 3 days ago
➤Don't forget to subscribe ! bit.ly/SubscribeJMSpeedshop
➤Website: jmspeedshop.com
➤instagram: instagram.com/johanmuter
my to do list from last video is all done
Startmotor start solenoide wiring installed
Needed to re wire it because it was to short
Also rooted now into the car and outside at the passenger side
foor well
also the horn's are placed now under the passenger side headlamp
oem placement is in front of the radiator but there is no room
Oem cable lenght was long enough so easy fix
Got the oil pressure sensor in place the will give me a full reading in the VEMS ecu i will use this until the car is in fully running condition and remapped . When this is stable order i wll put the
OEm S600 pressure sensor back inplace that will work with y dashboard like oem so that all the dials are working again.
Also the wiring for this sensor is in place with a Ground cable to the chassis so i don't have a ground failure that i had with the 190e sensor that only uses a chassis ground
Cooling water temp for the dash is also in place this is the OEM wire. I only placed wire protection cover
Place the OEm wire of the sump level sensor
this will also work with the dashboard
so next video will be about the VEMS software
thanks for watching
JMSpeedshop.com
➤Don't forget to subscribe ! bit.ly/SubscribeJMSpeedshop
➤Website: jmspeedshop.com
➤instagram: instagram.com/johanmuter
my to do list from last video is all done
Startmotor start solenoide wiring installed
Needed to re wire it because it was to short
Also rooted now into the car and outside at the passenger side
foor well
also the horn's are placed now under the passenger side headlamp
oem placement is in front of the radiator but there is no room
Oem cable lenght was long enough so easy fix
Got the oil pressure sensor in place the will give me a full reading in the VEMS ecu i will use this until the car is in fully running condition and remapped . When this is stable order i wll put the
OEm S600 pressure sensor back inplace that will work with y dashboard like oem so that all the dials are working again.
Also the wiring for this sensor is in place with a Ground cable to the chassis so i don't have a ground failure that i had with the 190e sensor that only uses a chassis ground
Cooling water temp for the dash is also in place this is the OEM wire. I only placed wire protection cover
Place the OEm wire of the sump level sensor
this will also work with the dashboard
so next video will be about the VEMS software
thanks for watching
JMSpeedshop.com










![[ Mercedes 190 V12 project ] all cooler are mounted and new intakes !! JMSpeedshop !
➤Dont forget to subscribe ! http://bit.ly/SubscribeJMSpeedshop
➤Website: http://jmspeedshop.com
➤instagram: https://www.instagram.com/johanmuter/
radiator was already fitted. but i got also the oil cooler and the transmission cooler mounted in place
the facelift bumpers are in place. to test fit.
got the ventillation openings created. in the bumpers
and with minor mods to the bumper it will fit perfectly around the bigger cooler pack.
als got a plan for the are intakes
have look [ Mercedes 190 V12 project ] all cooler are mounted and new intakes !! JMSpeedshop !](https://i.ytimg.com/vi/Qgp4ArjRsX4/mqdefault.jpg)