Uploaded July 2024 | Updated September 2026, 1 week ago
Heck, curious if this will be like my old Titan extruder!
I used a 5mm bore, 9mm O,.D. bearing. It's too large by about 1mm/.5 per side. The door does not close all the way, but it is putting pressure on the filament. Need a 5mm or maybe even 3mm bore, 8mm O.D. bearing, 4mm wide.
I decided to get a straight gear as I hear a lot the twirl is not good. So I hope to get another perspective with straight vs twirl, or so I hope.
Gonna see if I can tell any difference.
Heck, curious if this will be like my old Titan extruder!
I used a 5mm bore, 9mm O,.D. bearing. It's too large by about 1mm/.5 per side. The door does not close all the way, but it is putting pressure on the filament. Need a 5mm or maybe even 3mm bore, 8mm O.D. bearing, 4mm wide.
I decided to get a straight gear as I hear a lot the twirl is not good. So I hope to get another perspective with straight vs twirl, or so I hope.
Gonna see if I can tell any difference.
