UncommentatedPannen | TTC Stomp on the Thwomp Faster HOLP @UncommentatedPannen | Uploaded 5 years ago | Updated 18 hours ago
I show a faster method of setting the HOLP that's necessary for collecting TTC Stomp on the Thwomp in 2 A presses. Thanks to Sidney (youtube.com/channel/UCla5Eru3DbPgxz6LwSBOyaw) for pointing out that we may be able to set this HOLP in WF by going on King Whomp's head.
Note: Currently, the most optimal way to get to the top of BitS (without using a one-time HOLP setting opportunity) is to use a preset HOLP from BoB (youtu.be/PZOGMmRWvPg), which takes some time to set up. Thus, I estimate that using WF instead of BitS for the HOLP placement for TTC Stomp on the Thwomp saves about 10 minutes in all.
For the record, the new HOLP I used was (421.8568115, 4331.01709, -1790.893066), and the bob-omb was thrown at angle 51456.
I show a faster method of setting the HOLP that's necessary for collecting TTC Stomp on the Thwomp in 2 A presses. Thanks to Sidney (youtube.com/channel/UCla5Eru3DbPgxz6LwSBOyaw) for pointing out that we may be able to set this HOLP in WF by going on King Whomp's head.
Note: Currently, the most optimal way to get to the top of BitS (without using a one-time HOLP setting opportunity) is to use a preset HOLP from BoB (youtu.be/PZOGMmRWvPg), which takes some time to set up. Thus, I estimate that using WF instead of BitS for the HOLP placement for TTC Stomp on the Thwomp saves about 10 minutes in all.
For the record, the new HOLP I used was (421.8568115, 4331.01709, -1790.893066), and the bob-omb was thrown at angle 51456.