Tight Enough to Fail - Short #309 @HVACS
Tight Enough to Fail - Short #309  @HVACS
Uploaded October 2026 | Updated November 2026, 3 hours ago
In this short podcast episode, Bryan discusses electrical connections and whether tighter is better (or if a connection is tight enough to fail).

Torque is a turning effect; force is applied at a distance from the screw's center, and that force creates pressure at the connection. A quarter-turn doesn't tell us how much force we have applied. You may notice a tight screw with other signs of a poor connection, like discoloration; tightening the connection may not help.

At a connection, we want very little resistance to current flow, and we get increased resistance and heat where we don't want it when connections are poor; according to Watt's law, when the resistance stays the same, doubling the current creates four times the heating power. However, temperature alone doesn't tell you the cause; thermal imaging is useful evidence, but we need operating conditions and current measurements, too.

The key takeaway is that tightening the connection as much as possible may do more harm than good; having a torque screwdriver and using it can help. When making new connections, use the torque screwdriver to torque to the proper specs right out of the gate. We must also consider wire sizing, wire placement, exposed conductors, and unacceptable double lugging. We must also be mindful of ferrules, including proper selection and crimping. Make all adjustments safely (without voltage), and if you do not have the manufacturer's data immediately available, look it up. Eventually, you will get an idea of what "good" looks like.

Remember: tighter doesn't necessarily mean better.

This episode contains embedded sponsor messages from Refrigeration Technologies, Carrier, NAVAC, Filtrete, and the 2027 AHR Expo.

Resources

Tightening Electrical Threaded Terminal Connections (tech tip) HVAC School calculators Submit a podcast question Learn about the GRIT Foundation Purchase your tickets or learn more about the 8th Annual HVACR Training Symposium at hvacrschool.com/symposium.
Tight Enough to Fail - Short #309How to Fix Attic Humidity Problems with Santa Fe Ultra Series DehumidifierHow to Set Up and Run a Blower Door Test 3DHVAC Repair Tips: Crankcase Heaters and Refrigerant ChargingThe MERV Myth - Airflow & Static PressureVacuum Pump Gas Ballast Deep Dive - Moisture, Oil & Maintenance | NAVAC | AHR Expo 2026Why and How to Test Heat Pump Defrost - Short #310Stop HVAC Communication Errors with Shielded CableThe Science Behind Torch Tips Every HVAC Tech Must KnowHow to Replace a Condenser Fan Motor w/ Jesus SantiagoCrankcase Heater Wiring | SureSwitch vs Standard ContactorsNAVAC SK3TPH1 Smart Probe Kit Unboxing | Wireless HVAC Diagnostic Kit
HVAC School |

Tight Enough to Fail - Short #309

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER