Uploaded March 2023 | Updated September 2026, 2 hours ago
This is an experimental change to simulate a diagonal in-feed as shown in @machinists-shortcuts video youtube.com/watch?v=uqm1-uEaE4c
I've updated my Electronic Leadscrew threading function to follow the recommendation by adding a Z offset which is half the depth of cut at each pass that results in a ~26.5 degree in-feed angle. It results in a much cleaner cut, with better chip formation.
#machining #australianmachinist #threading #electronicleadscrew #els
This is an experimental change to simulate a diagonal in-feed as shown in @machinists-shortcuts video youtube.com/watch?v=uqm1-uEaE4c
I've updated my Electronic Leadscrew threading function to follow the recommendation by adding a Z offset which is half the depth of cut at each pass that results in a ~26.5 degree in-feed angle. It results in a much cleaner cut, with better chip formation.
#machining #australianmachinist #threading #electronicleadscrew #els
