Uploaded May 2021 | Updated November 2026, 2 hours ago
A bandwidth and multiplication factor measurement on the Tesla coil with the new ground plane fitted, done with a signal generator and a field strength meter. The resonant peak is found at 5674 kilocycles, then the frequency is walked down and back up in hundred-cycle steps to the points where the needle falls to about 70 percent, and the spread between them gives the bandwidth. Eric then explains the design principle: no primary and secondary, just an extra coil that is one wavelength fraction, with current living at one end and voltage at the other, fed from a step down transformer of about 2.5 ohms that must approach a source of constant potential and zero impedance.
Chapters
0:00 Setting up the field strength meter
1:59 Peaking at the resonant frequency
4:59 Walking down to the 70 percent point
8:25 Why there is no primary or secondary
ericpdollard.com/donate
emediapress.com
emediapress.com/energytimes
Eric Dollard Tesla coil measurements. Recorded 2021-03-29.
A bandwidth and multiplication factor measurement on the Tesla coil with the new ground plane fitted, done with a signal generator and a field strength meter. The resonant peak is found at 5674 kilocycles, then the frequency is walked down and back up in hundred-cycle steps to the points where the needle falls to about 70 percent, and the spread between them gives the bandwidth. Eric then explains the design principle: no primary and secondary, just an extra coil that is one wavelength fraction, with current living at one end and voltage at the other, fed from a step down transformer of about 2.5 ohms that must approach a source of constant potential and zero impedance.
Chapters
0:00 Setting up the field strength meter
1:59 Peaking at the resonant frequency
4:59 Walking down to the 70 percent point
8:25 Why there is no primary or secondary
ericpdollard.com/donate
emediapress.com
emediapress.com/energytimes
Eric Dollard Tesla coil measurements. Recorded 2021-03-29.










