Uploaded September 2021 | Updated November 2026, 3 hours ago
A conference preview on Robert Adams's pulsed electric motor, presented by a software engineer from Amsterdam who has built one, introduced by Aaron Murakami. Peter Lindemann corresponded with Adams for years and supplied letters and photographs that had not been seen publicly, including Adams's calorimetry rigs, which the presenter notes Adams trusted over any multimeter. The design points covered are an air gap of about 1.25 millimeters, a specified 72 ohm drive coil, and Adams's claim that under full load the motor stays within about 20 degrees Celsius of ambient and needs no cooling. The practical warning is about the switching: Adams used a mechanical contact on a timing disk and said that replacing it with transistors loses the battery charging effect, which the presenter suggests is why so many replications fall short. The claims described are Adams's own.
Chapters
0:00 Who Robert Adams was
1:40 Peter Lindemann's correspondence and photographs
3:11 What Adams claimed for the machine
4:41 Why the motor stays cool
6:13 His timing disk and duty cycle
7:43 Why the mechanical switch matters
9:05 Calorimetry rather than a multimeter
10:43 Where the energy is said to come from
emediapress.com/product-category/energy-science-technology-conference/2021
emediapress.com/conference
emediapress.com
emediapress.com/energytimes
2021 Energy Science & Technology Conference preview. Posted 2021-09-01.
A conference preview on Robert Adams's pulsed electric motor, presented by a software engineer from Amsterdam who has built one, introduced by Aaron Murakami. Peter Lindemann corresponded with Adams for years and supplied letters and photographs that had not been seen publicly, including Adams's calorimetry rigs, which the presenter notes Adams trusted over any multimeter. The design points covered are an air gap of about 1.25 millimeters, a specified 72 ohm drive coil, and Adams's claim that under full load the motor stays within about 20 degrees Celsius of ambient and needs no cooling. The practical warning is about the switching: Adams used a mechanical contact on a timing disk and said that replacing it with transistors loses the battery charging effect, which the presenter suggests is why so many replications fall short. The claims described are Adams's own.
Chapters
0:00 Who Robert Adams was
1:40 Peter Lindemann's correspondence and photographs
3:11 What Adams claimed for the machine
4:41 Why the motor stays cool
6:13 His timing disk and duty cycle
7:43 Why the mechanical switch matters
9:05 Calorimetry rather than a multimeter
10:43 Where the energy is said to come from
emediapress.com/product-category/energy-science-technology-conference/2021
emediapress.com/conference
emediapress.com
emediapress.com/energytimes
2021 Energy Science & Technology Conference preview. Posted 2021-09-01.










