Standalone Full Bridge DC Motor Driver @MyVanitar
Standalone Full Bridge DC Motor Driver  @MyVanitar
Uploaded October 2022 | Updated November 2026, 3 days ago
Standalone Full Bridge (H Bridge) DC Motor Driver using Tiny13 and IR2104
======================================
Altium Designer + License (Free): altium.com/yt/myvanitar
OctoPart: octopart.com
======================================
Article: pcbway.com/blog/technology/A_Standalone_Full_Bridge_DC_Motor_Driver_2c7c2086.html
======================================
Other Videos: bit.ly/2N9OlPa
======================================
The Full-Bridge (H-Bridge) is the most popular driver circuit to control brushed DC motors. The main advantage of a full bridge driver is the ability to change the rotation direction of the motor, without manually reversing the supply wires. I’ve already published the Half-bridge and H-bridge driver circuits before; however, I was receiving many requests and comments for a standalone H-Bridge driver to control the DC motors, without using any external board or a controller.
Therefore, I introduced a cheap, compact, and standalone H-Bridge DC motor driver that can be embedded in a variety of mechatronic devices. A cheap ATTiny13 microcontroller controls everything and I used the Arduino IDE to write the microcontroller code. All components, except for the connectors, are SMD.
The motor can be controlled in three modes: Forward, Stop, and Reverse. The user can adjust the rotation speed of the motor separately in the forward or reverse direction, using two panel-mounting potentiometers. The low ON-Resistance of the Mosfets allows you to use this circuit in high currents.
To design the schematic and PCB, I used Altium Designer 22. The fast component search engine (octopart) allowed me to quickly collect the components’ data and generate the BOM as well. To get high-quality fabricated boards, I sent the Gerber files to PCBWay. To test the driver board, I disassembled an electric toy car and used its powerful 775 DC motor (plus the gearbox).
It’s a cool experience, just build one and have fun!

Specifications
Input Voltage (Motor): 8-40VDC
Supply Voltage (Controller): 12VDC
PWM Frequency: 25KHz
Motor Control: Forward-Stop-Reverse
Motor Speed: [0 to 100%] Forward, [0 to 100%] Reverse
Standalone Full Bridge DC Motor DriverCheap PIR Motion Sensor RepairEasy desoldering on a multilayer PCBCompact 2.5V-5.5V to 3.3V-1.5A Buck-Boost Converter (TPS63020)Starmax Digital Satellite Receiver No Power/Boot Loop Repair85V-260VAC to 5VDC-2.5A Flyback Switching Power SupplyDigital FM Receiver (Radio) Circuit with Arduino + Stereo Amplifier🔶 Temperature & Humidity Control Unit Using a Raspberry Pi PicoIR Remote Control Decoder/Switcher CircuitLow Noise AC to DC Rectifier Using Capacitance Multiplier [Altium Designer]Active Low Pass Filter Circuit Analysis using Siglent SDS2102X Plus Oscilloscope [Part-1]AC RMS Current Measurement Using the Siglent SDS2000X Plus Oscilloscope
MyVanitar |

Standalone Full Bridge DC Motor Driver

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER