Uploaded November 2025 | Updated November 2026, 5 days ago
Here's a fast way to skin parts with carbon fiber.
Instead of brushing the epoxy, I use the resin infusion technique to saturate the carbon fiber
with resin.
The vacuum will hold the Carbonfiber tightly on the part and wont lift on corners or complex geometries.
Other advantage is the fibers will lay very flat on the part.
After curing, the vacuumbag and the peelply can be removed. It's better to sand the peelply texture flat before applying
the high gloss pattern coat. This coat will smoothen out the part with a nice clear layer. If you still have imperfections, repeat this step as many times as needed. I would advice you to use a layer of clearcoat as a finish and protection against UV.
Here's a fast way to skin parts with carbon fiber.
Instead of brushing the epoxy, I use the resin infusion technique to saturate the carbon fiber
with resin.
The vacuum will hold the Carbonfiber tightly on the part and wont lift on corners or complex geometries.
Other advantage is the fibers will lay very flat on the part.
After curing, the vacuumbag and the peelply can be removed. It's better to sand the peelply texture flat before applying
the high gloss pattern coat. This coat will smoothen out the part with a nice clear layer. If you still have imperfections, repeat this step as many times as needed. I would advice you to use a layer of clearcoat as a finish and protection against UV.










