Uploaded December 2025 | Updated September 2026, 1 week ago
I decided to help a friend and replaced all of his Roland Juno 60 sliders. I figured I’d done a lot of similar work for myself, and I’ve had a lot of people help me out so I wanted to pass it forward. Well, after spending 3 hours replacing the sliders, it was 12:30AM and I turned on the unit to test it out. But it went horribly wrong. Nothing sounded right. Noise was always present, the Attack slider didn’t work, Sub was always on, you get the picture. By this point, I was totally stressed out. I had destroyed a $3000 synth!
I tried going to sleep, but it was around 3AM before I could. I woke up the next day, stressed. I ran downstairs to see if it was just something simple I missed, but nothing seemed wrong. All the pins had continuity to the traces they were going towards.
By 5PM that day, I finally wrote on a facebook group. Someone mentioned something regarding the new sliders from Syntaur. He said they’re chassis legs are too short. Specifically, the Attack slider chassis provides ground to IC5, pin 8. But when I checked, there was continuity from the pad to IC5 pin 8. HOWEVER, the pad was NOT connected to the chassis. I quickly threw the old slider in, and magically… it all worked. I couldn’t believe it. That was about 24 hours of terror as I tried to figure out what went wrong.
However, it is now going strong, perfectly. I’m very thankful to that facebook group!
Fractal Audio FM3 used for delay/reverb/fx.
#rolandjuno #Juno #fractalaudiofm3
I decided to help a friend and replaced all of his Roland Juno 60 sliders. I figured I’d done a lot of similar work for myself, and I’ve had a lot of people help me out so I wanted to pass it forward. Well, after spending 3 hours replacing the sliders, it was 12:30AM and I turned on the unit to test it out. But it went horribly wrong. Nothing sounded right. Noise was always present, the Attack slider didn’t work, Sub was always on, you get the picture. By this point, I was totally stressed out. I had destroyed a $3000 synth!
I tried going to sleep, but it was around 3AM before I could. I woke up the next day, stressed. I ran downstairs to see if it was just something simple I missed, but nothing seemed wrong. All the pins had continuity to the traces they were going towards.
By 5PM that day, I finally wrote on a facebook group. Someone mentioned something regarding the new sliders from Syntaur. He said they’re chassis legs are too short. Specifically, the Attack slider chassis provides ground to IC5, pin 8. But when I checked, there was continuity from the pad to IC5 pin 8. HOWEVER, the pad was NOT connected to the chassis. I quickly threw the old slider in, and magically… it all worked. I couldn’t believe it. That was about 24 hours of terror as I tried to figure out what went wrong.
However, it is now going strong, perfectly. I’m very thankful to that facebook group!
Fractal Audio FM3 used for delay/reverb/fx.
#rolandjuno #Juno #fractalaudiofm3
