Uploaded November 2026 | Updated November 2026, 3 hours ago
We take a look at the RA6W1 Evaluation Kit from Renesas. The dual-band Wi-Fi 6 MCU is highly integrated and has ultra-low-power consumption for use in smart home, wearables, and other IoT devices.
Inside the box, you’ll find the motherboard with debugging and power measurement circuitry, the daughterboard with the RA6W1 chip, and a USB cable.
In this demo we’re going to program the RA6W1 with a Wi-Fi test firmware that will allow us to set it up over UART. Renesas provides many examples with source code so you can tailor your evaluation to your application.
Plug the daughterboard into the motherboard. Note that the daughterboard has a PCB antenna, so an external antenna is optional. For this demo, we also need to switch the position of all four jumpers on the J3 block and add two jumpers between J201 and J203. Connect a PC to the motherboard’s USB C port.
Load the firmware onto the board using the Renesas Flash Programmer tool. Once complete, open a serial terminal, configure it according to the quick start guide, and reset the board. Then enter the country code, select station mode, and proceed with the Wi-Fi configuration. Once complete, we can ping the kit, and the other examples allow you to do more detailed performance testing, power measurement, and demonstrate other functions.
renesas.com/en/products/ra6w1?tab=software-tools
digikey.com/en/products/detail/renesas-electronics-corporation/RTK7WKA6W1S04000BK/28022506
Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey
We take a look at the RA6W1 Evaluation Kit from Renesas. The dual-band Wi-Fi 6 MCU is highly integrated and has ultra-low-power consumption for use in smart home, wearables, and other IoT devices.
Inside the box, you’ll find the motherboard with debugging and power measurement circuitry, the daughterboard with the RA6W1 chip, and a USB cable.
In this demo we’re going to program the RA6W1 with a Wi-Fi test firmware that will allow us to set it up over UART. Renesas provides many examples with source code so you can tailor your evaluation to your application.
Plug the daughterboard into the motherboard. Note that the daughterboard has a PCB antenna, so an external antenna is optional. For this demo, we also need to switch the position of all four jumpers on the J3 block and add two jumpers between J201 and J203. Connect a PC to the motherboard’s USB C port.
Load the firmware onto the board using the Renesas Flash Programmer tool. Once complete, open a serial terminal, configure it according to the quick start guide, and reset the board. Then enter the country code, select station mode, and proceed with the Wi-Fi configuration. Once complete, we can ping the kit, and the other examples allow you to do more detailed performance testing, power measurement, and demonstrate other functions.
renesas.com/en/products/ra6w1?tab=software-tools
digikey.com/en/products/detail/renesas-electronics-corporation/RTK7WKA6W1S04000BK/28022506
Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey










