Uploaded January 2026 | Updated November 2026, 5 hours ago
We take a look at the EV94U98A Motor Control Evaluation Kit from Microchip. It’s based on the ATA6847L, which provides a comprehensive solution for three-phase brushless DC motor control.
Inside the box, you’ll find the main evaluation board featuring the ADA6847L gate driver. The kit also includes a microcontroller DIM board with a dsPIC33CK series MCU pre-loaded with demo firmware. Other DIM boards are available with other MCUs, or you can design your own.
In this demo, we’re going to set up the evaluation board, connect a 24-volt Hurst NT Dynamo motor and power supply, and monitor the three motor phases with an oscilloscope.
The control board plugs into the socket on the main board. Connect the motor phases to the three position terminal block and a 24 volt power supply to the two position terminal block. We’re also connecting our scope probes to the motor phases. Once everything is connected, turn on your power supply and the red fault LED will blink. Then press the run button.
With the motor running, you can adjust the speed with the potentiometer. Starting at the slowest setting, as we adjust the speed we can see pulse widths changing. Once we get to the max speed we’ll stop the capture so you can actually see them.
Microchip also provides the firmware so you can change the motor parameters or type, or use it as a starting point to write your own code.
digikey.com/en/products/base-product/microchip-technology/150/ATA6847T/737919
digikey.com/en/products/detail/microchip-technology/EV43F54A/25903974
Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey
We take a look at the EV94U98A Motor Control Evaluation Kit from Microchip. It’s based on the ATA6847L, which provides a comprehensive solution for three-phase brushless DC motor control.
Inside the box, you’ll find the main evaluation board featuring the ADA6847L gate driver. The kit also includes a microcontroller DIM board with a dsPIC33CK series MCU pre-loaded with demo firmware. Other DIM boards are available with other MCUs, or you can design your own.
In this demo, we’re going to set up the evaluation board, connect a 24-volt Hurst NT Dynamo motor and power supply, and monitor the three motor phases with an oscilloscope.
The control board plugs into the socket on the main board. Connect the motor phases to the three position terminal block and a 24 volt power supply to the two position terminal block. We’re also connecting our scope probes to the motor phases. Once everything is connected, turn on your power supply and the red fault LED will blink. Then press the run button.
With the motor running, you can adjust the speed with the potentiometer. Starting at the slowest setting, as we adjust the speed we can see pulse widths changing. Once we get to the max speed we’ll stop the capture so you can actually see them.
Microchip also provides the firmware so you can change the motor parameters or type, or use it as a starting point to write your own code.
digikey.com/en/products/base-product/microchip-technology/150/ATA6847T/737919
digikey.com/en/products/detail/microchip-technology/EV43F54A/25903974
Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey










