Uploaded August 2023 | Updated November 2026, 48 minutes ago
While it kind of seems like hitting the lottery on too many possible combinations.. playing around with the wheel hexes and how the wheels actually go on them can make a big difference. Since there is a pin that goes through the shaft the hex sits on there is only 2 possible ways that can go on. The wheel/tire itself can go on the hex 6 different ways and the idea is that eventually you may land on a fitment where most of the natural imperfections in the balance cancel each other out. Since each tire is not going to be identical as far as exact dimensions and how it was glued on the wheel, you may need to rotate which tires are going on which hex. The same goes for which hex goes on each shaft. I'm only going to get it to the point where the video is smooth enough to drive fast and it also doesn't want to unpredictably veer off when hitting full throttle. This is really only a problem for high speed driving as the sub-trim can be set to give straight steering, but that doesn't mean it's going to stay straight at that setting once the wheels start ballooning.
As for the camera gimbal I'm doing the bootleg supports because I don't want to invest in a more complex rig that possibly uses bearings or something. A 3D printed setup that allows an adjustment for a 'friction fitment' would be pretty easy and it would prevent play developing in the servo shaft. My servos are all supporting the weight of two cameras and a flashlight so they are going to wear faster.
While it kind of seems like hitting the lottery on too many possible combinations.. playing around with the wheel hexes and how the wheels actually go on them can make a big difference. Since there is a pin that goes through the shaft the hex sits on there is only 2 possible ways that can go on. The wheel/tire itself can go on the hex 6 different ways and the idea is that eventually you may land on a fitment where most of the natural imperfections in the balance cancel each other out. Since each tire is not going to be identical as far as exact dimensions and how it was glued on the wheel, you may need to rotate which tires are going on which hex. The same goes for which hex goes on each shaft. I'm only going to get it to the point where the video is smooth enough to drive fast and it also doesn't want to unpredictably veer off when hitting full throttle. This is really only a problem for high speed driving as the sub-trim can be set to give straight steering, but that doesn't mean it's going to stay straight at that setting once the wheels start ballooning.
As for the camera gimbal I'm doing the bootleg supports because I don't want to invest in a more complex rig that possibly uses bearings or something. A 3D printed setup that allows an adjustment for a 'friction fitment' would be pretty easy and it would prevent play developing in the servo shaft. My servos are all supporting the weight of two cameras and a flashlight so they are going to wear faster.










