Uploaded December 2023 | Updated September 2026, 2 weeks ago
If your printer bed looks more like a slip-n-slide, this is the video for you!
Help support this channel! patreon.com/Needitmakeit
In this video we first show the recommended way to level the bed, and yes it was better, but not nearly good enough. We have come up with a far better and easier way to do it from the top. If your bed was better than mine, you can use the method I came up with, but if it's worse, you probably want to do the same process as shown in the video.
There is a possible alternate method to get it close called the 'Tooth-skipping' method, but I've never tried it and I think it is a job better suited for two people.
I hope you found this video helpful and interesting!
Another way to support this channel indirectly is through my affiliate links (where I receive a small commission). It helps me to continue to provide high-quality content videos. Thank you for your support!
NEW MIC (I bought this)
amzn.to/3vcMKAr - Rode Wireless ME mic (Saved me about 4+ hours/vid)
amzn.to/3NBFvZe - Mag clip (Super handy, but a little pricy)
BAMBU PRINTERS
shrsl.com/4aghz
CREALITY PRINTERS
shrsl.com/4aghy
CREALITY HYPER PLA
shrsl.com/4aghn
Download spacers:
printables.com/model/681528-bed-shims-fits-creality-k1-and-k1-max
makerworld.com/en/models/92567
#creality
#crealityk1
#klipper
If your printer bed looks more like a slip-n-slide, this is the video for you!
Help support this channel! patreon.com/Needitmakeit
In this video we first show the recommended way to level the bed, and yes it was better, but not nearly good enough. We have come up with a far better and easier way to do it from the top. If your bed was better than mine, you can use the method I came up with, but if it's worse, you probably want to do the same process as shown in the video.
There is a possible alternate method to get it close called the 'Tooth-skipping' method, but I've never tried it and I think it is a job better suited for two people.
I hope you found this video helpful and interesting!
Another way to support this channel indirectly is through my affiliate links (where I receive a small commission). It helps me to continue to provide high-quality content videos. Thank you for your support!
NEW MIC (I bought this)
amzn.to/3vcMKAr - Rode Wireless ME mic (Saved me about 4+ hours/vid)
amzn.to/3NBFvZe - Mag clip (Super handy, but a little pricy)
BAMBU PRINTERS
shrsl.com/4aghz
CREALITY PRINTERS
shrsl.com/4aghy
CREALITY HYPER PLA
shrsl.com/4aghn
Download spacers:
printables.com/model/681528-bed-shims-fits-creality-k1-and-k1-max
makerworld.com/en/models/92567
#creality
#crealityk1
#klipper
