Gregs Maker Corner | Prusa Mini Build Live Stream @GregsMakerCorner | Uploaded December 2019 | Updated October 2024, 8 hours ago.
This is a live stream of my Prusa Mini build! I hope you find it useful.
I ordered my Prusa Mini about 30 minutes after the announcement at ERRF. I received it on Sunday, December 15th and the same evening I did this build.
Overall the build went quite well, especially compared to previous builds (Prusa Mk2, Mk3, Ender 3, CR10S, Hypercube Evo) and is by far the easiest printer I've ever built. It took about an hour, but if I were not streaming and focused I bet it could be done in 30-45 minutes.
My only suggestion to improve the build so far is to use "drop in" t-nuts / hammer nuts. That was the most challenging part of the build- getting the screw to line up into the t-nut.
I think this is going to be a very popular printer! Feel free to follow me at @greghuber on twitter. twitter.com/greghuber and ping me if any questions, or reply to this video.
This is a live stream of my Prusa Mini build! I hope you find it useful.
I ordered my Prusa Mini about 30 minutes after the announcement at ERRF. I received it on Sunday, December 15th and the same evening I did this build.
Overall the build went quite well, especially compared to previous builds (Prusa Mk2, Mk3, Ender 3, CR10S, Hypercube Evo) and is by far the easiest printer I've ever built. It took about an hour, but if I were not streaming and focused I bet it could be done in 30-45 minutes.
My only suggestion to improve the build so far is to use "drop in" t-nuts / hammer nuts. That was the most challenging part of the build- getting the screw to line up into the t-nut.
I think this is going to be a very popular printer! Feel free to follow me at @greghuber on twitter. twitter.com/greghuber and ping me if any questions, or reply to this video.
