Uploaded March 2022 | Updated September 2026, 3 weeks ago
This is part of my Voron 2.4 build series. Full playlist here:
youtube.com/playlist?list=PLpQnpsv1trbQxzX1zIVISOJtE6Pnb-si6
In this video I demonstrate how to assemble the bed extrusions, prepare, lube, and install the 4 "Z" Rails and the DIN mounts that go on the bottom deck.
For DIN rail mounting, I am going with an "LDO Kit" inspired mounting style, which means I mount them parallel to the extrusions. The manual has them going perpendicular. You can see how I ultimately installed and configured them in my wiring video- I ended up going with slightly shorter DIN mounts but left them in the same orientation.
I am using a syringe of the Mobliux Ep2 oil purchased from West 3d here:
west3d.com/products/mobil-mobilux-ep2-10ml-filled-syringe-with-blunt-tip
This is part of my Voron 2.4 build series. Full playlist here:
youtube.com/playlist?list=PLpQnpsv1trbQxzX1zIVISOJtE6Pnb-si6
In this video I demonstrate how to assemble the bed extrusions, prepare, lube, and install the 4 "Z" Rails and the DIN mounts that go on the bottom deck.
For DIN rail mounting, I am going with an "LDO Kit" inspired mounting style, which means I mount them parallel to the extrusions. The manual has them going perpendicular. You can see how I ultimately installed and configured them in my wiring video- I ended up going with slightly shorter DIN mounts but left them in the same orientation.
I am using a syringe of the Mobliux Ep2 oil purchased from West 3d here:
west3d.com/products/mobil-mobilux-ep2-10ml-filled-syringe-with-blunt-tip
