Uploaded January 2025 | Updated September 2026, 3 weeks ago
this is part 7 of my Voron Build, almost all linear rails come with factory grease / protectant on them and this needs to be cleaned off completly and then re lubricate the bearings before installation and use. That's what I do in this video.
I completly strip down the carriage , remove all bearings etc., clean, lubricate and reassemble.
Not a sponsored video but if a vendor wants to reach out, please do I would love the help but without pre-conditions on video content.
A lot of parts I have already from years of Industrial control projects, 3D printer builds and other electronic projects.
I am creating a series of detailed videos showing the progress of building a superior 3D printer with minimal cost leveraging spare parts and salvaged parts were appropriate. Future project will I hope include evaluation of kit builds and more.
this is part 7 of my Voron Build, almost all linear rails come with factory grease / protectant on them and this needs to be cleaned off completly and then re lubricate the bearings before installation and use. That's what I do in this video.
I completly strip down the carriage , remove all bearings etc., clean, lubricate and reassemble.
Not a sponsored video but if a vendor wants to reach out, please do I would love the help but without pre-conditions on video content.
A lot of parts I have already from years of Industrial control projects, 3D printer builds and other electronic projects.
I am creating a series of detailed videos showing the progress of building a superior 3D printer with minimal cost leveraging spare parts and salvaged parts were appropriate. Future project will I hope include evaluation of kit builds and more.
