atkelar | Precision ES-500 (Part 3/3) @atkelar | Uploaded September 2023 | Updated October 2024, 12 hours ago.
Workshop Project #25 - Precision ES-500
The final part of the restoration / rebuild effort is going to finally put tubes under power! It's beeen a really long time! But now: main signal turn on!
0:00 Intro / Resistor Divider / "Neck Board" and Wire Issues
2:25 CRT Turn On! / Centering Issue
4:00 CRT Rotation Alignment and Bezel / Heater Lines / First Binding Post
6:18 3D Soldering / First Input Stage Wiring
7:46 VR150 Check / 6J5 Check / Driver Stage Wiring
8:56 Revision in Amplifier / Driver Stage Finalizing / Vertical Deflection!
10:30 Attenuator Rebuild / Adjustments
11:55 Horizontal Section Start / Selection Switch Wiring
14:00 Sawtooth...ish? / Horizontal Test / Troubleshooting / Wiring Loom
15:50 Twitching Problem / Troubleshooting
16:50 Final Overview / Case Closed
17:45 Feature Overview: Range, Coupling, Sync, Gain, Phones, Beam Mod., Ext Sync., 6V, Phasing
21:00 Wierd Noise...? / Credits
Part 1 is here - youtube.com/watch?v=f-CteoZsIOc
Part 2 is here - youtube.com/watch?v=LrDv40FFSFc
Music:
My Train's A Comin'
Unicorn Heads
(YouTube Audio Library)
"Walking Atkelar" Animation: Snapai
You can support me on Ko-Fi: ko-fi.com/atkelar
and also on Patreon: patreon.com/Atkelar
Thanks to everybody who signed up already!
Workshop Project #25 - Precision ES-500
The final part of the restoration / rebuild effort is going to finally put tubes under power! It's beeen a really long time! But now: main signal turn on!
0:00 Intro / Resistor Divider / "Neck Board" and Wire Issues
2:25 CRT Turn On! / Centering Issue
4:00 CRT Rotation Alignment and Bezel / Heater Lines / First Binding Post
6:18 3D Soldering / First Input Stage Wiring
7:46 VR150 Check / 6J5 Check / Driver Stage Wiring
8:56 Revision in Amplifier / Driver Stage Finalizing / Vertical Deflection!
10:30 Attenuator Rebuild / Adjustments
11:55 Horizontal Section Start / Selection Switch Wiring
14:00 Sawtooth...ish? / Horizontal Test / Troubleshooting / Wiring Loom
15:50 Twitching Problem / Troubleshooting
16:50 Final Overview / Case Closed
17:45 Feature Overview: Range, Coupling, Sync, Gain, Phones, Beam Mod., Ext Sync., 6V, Phasing
21:00 Wierd Noise...? / Credits
Part 1 is here - youtube.com/watch?v=f-CteoZsIOc
Part 2 is here - youtube.com/watch?v=LrDv40FFSFc
Music:
My Train's A Comin'
Unicorn Heads
(YouTube Audio Library)
"Walking Atkelar" Animation: Snapai
You can support me on Ko-Fi: ko-fi.com/atkelar
and also on Patreon: patreon.com/Atkelar
Thanks to everybody who signed up already!