Uploaded March 2022 | Updated September 2026, 6 hours ago

---

This video goes along with the step by step instructions on my website, which can be viewed here: makethingswithrob.com/finish_table

In this video we'll make the pads for the dog hole finishing board.

To make the cone set screws, follow this link (Thanks Brian Davern!): youtu.be/h3dXMME2vcw

0:00 Intro
0:24 Circle jig
2:17 Pad creation
2:47 Adding Carpet Utility Runner
5:13 Using the Circle Jig
7:11 Adding Cone Set Screws
9:29 Adding magnets to the center