Uploaded April 2026 | Updated November 2026, 3 hours ago
A demonstration of all the ways that you can get 100 rabbits' Orca esoteric programming language to communicate with TouchDesigner: MIDI, OSC, and UDP (in both directions)
A demonstration of all the ways that you can get 100 rabbits' Orca esoteric programming language to communicate with TouchDesigner: MIDI, OSC, and UDP (in both directions)




![[UPDATED] CNC Routing with Fusion 360: How to avoid radiused inside corners
A remake of the video that I made to describe how we can make dogbone fillets in Autodesk Fusion 360. Autodesk actually included a link to the video in their Fusion News newsletter, but a couple commenters alerted me to the fact that I had a mistake in the video. This one is shorter, more correct, and more to the point. Good luck!
A great dogbone fillet Add-In for Fusion 360: https://github.com/caseycrogers/Dogbone
The CNC Joinery Notebook:
http://makezine.com/2012/04/13/cnc-panel-joinery-notebook/
PS: I didnt mention it, but note that the dogbones that face downward can effectively hide the solution, so that might be the best option if your bit/endmill isnt too big (in which case youll be cutting away too much of the edge at the end of your slot). [UPDATED] CNC Routing with Fusion 360: How to avoid radiused inside corners](https://i.ytimg.com/vi/oZDBR5QtjgA/mqdefault.jpg)





