Uploaded September 2026 | Updated November 2026, 4 days ago
Quick video showing you how to fix a First Alert Carbon Monoxide Detector with only one chirp per minute and needing the battery to be replaced.
How to fix it
Remove the First Alert CO detector from its mounting bracket, if necessary.
Open the battery compartment.
Remove the old battery/batteries.
Install the correct new battery type specified for your particular model.
Make sure the battery is firmly connected and the compartment is completely closed.
Press the Test/Silence button to verify that the alarm works.
The once-per-minute chirp should stop once the detector recognizes the fresh battery.
If it keeps chirping after a new battery
Don't immediately assume the new battery is bad.
Check:
Is the battery installed in the correct direction?
Is it actually a fresh battery?
Are the battery terminals making good contact?
Is the battery compartment completely closed?
Is the detector actually past its service life?
This last one is important. First Alert says different models use different chirp patterns for malfunction and end-of-life conditions, so you should check the model-specific manual.
For example, the CO400 manual specifically identifies one chirp every minute with a flashing red light as a low-battery warning and instructs you to install new batteries. It also identifies three quick chirps every minute as a malfunction signal.
Don't confuse a chirp with a CO alarm
One chirp every minute: maintenance/low-battery warning.
Four loud beeps followed by a pause, repeating: possible carbon monoxide emergency. First Alert says to move to fresh air immediately and call 911 rather than trying to reset the detector.
Disclaimer: As an Amazon Associate I earn from qualified purchases.
Quick video showing you how to fix a First Alert Carbon Monoxide Detector with only one chirp per minute and needing the battery to be replaced.
How to fix it
Remove the First Alert CO detector from its mounting bracket, if necessary.
Open the battery compartment.
Remove the old battery/batteries.
Install the correct new battery type specified for your particular model.
Make sure the battery is firmly connected and the compartment is completely closed.
Press the Test/Silence button to verify that the alarm works.
The once-per-minute chirp should stop once the detector recognizes the fresh battery.
If it keeps chirping after a new battery
Don't immediately assume the new battery is bad.
Check:
Is the battery installed in the correct direction?
Is it actually a fresh battery?
Are the battery terminals making good contact?
Is the battery compartment completely closed?
Is the detector actually past its service life?
This last one is important. First Alert says different models use different chirp patterns for malfunction and end-of-life conditions, so you should check the model-specific manual.
For example, the CO400 manual specifically identifies one chirp every minute with a flashing red light as a low-battery warning and instructs you to install new batteries. It also identifies three quick chirps every minute as a malfunction signal.
Don't confuse a chirp with a CO alarm
One chirp every minute: maintenance/low-battery warning.
Four loud beeps followed by a pause, repeating: possible carbon monoxide emergency. First Alert says to move to fresh air immediately and call 911 rather than trying to reset the detector.
Disclaimer: As an Amazon Associate I earn from qualified purchases.










