Uploaded September 2017 | Updated November 2026, 2 hours ago
The video is my synthesizer. It's from just after this audio was recorded, so that's how it looks with this whole patch set up. Of course when I was recording the audio, there was a lot of knob-twisting going on.
I'm musically limited right now by having only one sequencer that can produce melodies. A giga-sequencer is my current project
The snare is noise from a reverse-biased transistor run through a simple adjustable low pass filter,
At 2:09 the "kick drum solo" starts. 808 kick modded with pitch control and extended delay through an "Engineer's Thumb" compressor built with BJT opamps instead of the required JFET opamps.
ericarcher.net/wp-content/uploads/2014/07/tr-808-bass-drum-diy-project.pdf
valvewizard.co.uk/engineersthumb.html
At 5:00 the drone comes in. Waveform shifts from square-like to triangle.
At 7:00 I remember that the melody is running through a wave multiplier -- the middle section from Ken Stone's Serge Wave Multiplier
cgs.synth.net/modules/cgs113_vcm.html
At 10:00 I decide to really mess with the melody oscillator. FM synthesis from another oscillator, fiddling with the waveforms and frequency from LFO to beyond-my-hearing high. These oscillators are designed by Thomas Henry -- X-4046, modded so that the "sine round" potentiometer is on the front. This sweeps from a triangle wave, through a nearly perfect sine wave to a square wave that has a slight triangular peak on the top, making it a house wave. A HOUSE WAVE!!!
birthofasynth.com/Thomas_Henry/Pages/X-4046.html
Not much new happens after 13:00 -- I had to go do a bed check.
The video is my synthesizer. It's from just after this audio was recorded, so that's how it looks with this whole patch set up. Of course when I was recording the audio, there was a lot of knob-twisting going on.
I'm musically limited right now by having only one sequencer that can produce melodies. A giga-sequencer is my current project
The snare is noise from a reverse-biased transistor run through a simple adjustable low pass filter,
At 2:09 the "kick drum solo" starts. 808 kick modded with pitch control and extended delay through an "Engineer's Thumb" compressor built with BJT opamps instead of the required JFET opamps.
ericarcher.net/wp-content/uploads/2014/07/tr-808-bass-drum-diy-project.pdf
valvewizard.co.uk/engineersthumb.html
At 5:00 the drone comes in. Waveform shifts from square-like to triangle.
At 7:00 I remember that the melody is running through a wave multiplier -- the middle section from Ken Stone's Serge Wave Multiplier
cgs.synth.net/modules/cgs113_vcm.html
At 10:00 I decide to really mess with the melody oscillator. FM synthesis from another oscillator, fiddling with the waveforms and frequency from LFO to beyond-my-hearing high. These oscillators are designed by Thomas Henry -- X-4046, modded so that the "sine round" potentiometer is on the front. This sweeps from a triangle wave, through a nearly perfect sine wave to a square wave that has a slight triangular peak on the top, making it a house wave. A HOUSE WAVE!!!
birthofasynth.com/Thomas_Henry/Pages/X-4046.html
Not much new happens after 13:00 -- I had to go do a bed check.










