Uploaded February 2021 | Updated September 2026, 1 hour ago
In this video, I make an Industrial Style Metal Handle. I love the look of industrial furniture and all the decor that comes with it, and this handle has the look I like. I hope you enjoy my video of the rebar handle project. It was a lot of fun to make.
The wide flat bar is 3mm thick, 43mm wide, and 225 mm long. The small flat bar is 3mm thick, 20mm wide, and 180mm long. The rebar is 13mm.
The main tools used are a MIG welder, angle grinder, drill, and bench vise.
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
In this video, I make an Industrial Style Metal Handle. I love the look of industrial furniture and all the decor that comes with it, and this handle has the look I like. I hope you enjoy my video of the rebar handle project. It was a lot of fun to make.
The wide flat bar is 3mm thick, 43mm wide, and 225 mm long. The small flat bar is 3mm thick, 20mm wide, and 180mm long. The rebar is 13mm.
The main tools used are a MIG welder, angle grinder, drill, and bench vise.
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
