Layout of YT Studio Workshop in Fusion360 #workshop @UDoIt2

Uploaded May 2025 | Updated September 2026, 3 weeks ago

Building the 4x8 PlasmaCNC pushed me to the point of organizing my YouTube Studio Workshop. I have plenty of room, I just need to organize it better. Normally, I would use Adobe Illustrator for a layout but I love Fusion360 just as much so that's what I'm using. I took measurements of every wall, window and door as well as every piece of equipment. I added this to the sketch so I can move things around. I figured out the layout down to a few inches.

Video Credits:
Video Production: U Do It™️ Studios a Division of No Cheese Records LLC All Rights Reserved. No Cheese Records® is a Registered Trademark of No Cheese Records LLC All Rights Reserved.

#workshop #youtube #studio #layout #organizing

Layout of YT Studio Workshop in Fusion360 #workshop

Repeatable setup is locked in for drilling center #metalfab

U Do It Reviews Lighting - Modern Outdoor Lighting Fixtures

Designing a Part in Fusion 360 for 3D Printing

4x8 PlasmaCNC Frame is Complete and I had no idea it was this big

Its that time of year to rake the leaves with U Do It

All I want is drill presses with freakin laser beams #laser

VidSummit interview with Rob Actis voice actor and best selling author of The Law of Action

Using my VCT Transfer Punch to find center of scribe on drill press #machining

Getting the main parts cut and drilled for my PlasmaCNC

I built a ridge beam and its uneven - using the DeWalt DCP580

Designing in Fusion 360 an End Cap for a Vinyl Railing and 3D Printing It - Episode 1