Repeatable setup is locked in for drilling center #metalfab @UDoIt2

Uploaded April 2025 | Updated September 2026, 3 weeks ago

Locked in my clamping setup for a repeatable center of this 2-inch square tubing. So now I can just make a mark from the ends and line up the center of the bit on that mark and be ready! Well, not so simple but we're getting there.

Video Credits:
Video Production: U Do It™️ Studios a Division of No Cheese Records LLC All Rights Reserved. No Cheese Records® is a Registered Trademark of No Cheese Records LLC All Rights Reserved.

Repeatable setup is locked in for drilling center #metalfab

U Do It Reviews Lighting - Modern Outdoor Lighting Fixtures

Designing a Part in Fusion 360 for 3D Printing

4x8 PlasmaCNC Frame is Complete and I had no idea it was this big

Its that time of year to rake the leaves with U Do It

All I want is drill presses with freakin laser beams #laser

VidSummit interview with Rob Actis voice actor and best selling author of The Law of Action

Using my VCT Transfer Punch to find center of scribe on drill press #machining

Getting the main parts cut and drilled for my PlasmaCNC

I built a ridge beam and its uneven - using the DeWalt DCP580

Designing in Fusion 360 an End Cap for a Vinyl Railing and 3D Printing It - Episode 1

Fabricating a DIY lumber rack using steel