Uploaded July 2026 | Updated September 2026, 2 hours ago
🚨 Is your laser engraving quality getting worse for no obvious reason?
If your engravings are starting to look fuzzy, inconsistent, or just not as crisp as they used to, don’t assume it’s your settings.
After chasing the problem on my OneLaser XRF, I discovered the real culprit: worn rubber guide wheels.
In this video, I show:
âś… How to tell if your guide wheels are causing problems
âś… How to replace them
âś… Why this simple maintenance restored my engraving quality
This applies directly to the OneLaser XRF and OneLaser XT, and the same guide wheel setup is also found on machines like the Thunder Laser Thunder Bolt, so this may save you hours of troubleshooting.
Regular maintenance is one of the most overlooked ways to keep your laser producing clean, accurate engravings—and this is one of those fixes that’s inexpensive but can make a huge difference.
👇 Have you ever noticed your engraving quality slowly getting worse? What ended up being the cause?
Check out OneLaser machines here:
1laser.com/beardedbuilds
Discount code- BEARDEDBUILDS
#LaserEngraving #OneLaser #OneLaserXRF #OneLaserXT #ThunderBolt #ThunderLaser #LightBurn #LaserMaintenance #CO2Laser #SmallBusiness #Maker #LaserBusiness #DIY
🚨 Is your laser engraving quality getting worse for no obvious reason?
If your engravings are starting to look fuzzy, inconsistent, or just not as crisp as they used to, don’t assume it’s your settings.
After chasing the problem on my OneLaser XRF, I discovered the real culprit: worn rubber guide wheels.
In this video, I show:
âś… How to tell if your guide wheels are causing problems
âś… How to replace them
âś… Why this simple maintenance restored my engraving quality
This applies directly to the OneLaser XRF and OneLaser XT, and the same guide wheel setup is also found on machines like the Thunder Laser Thunder Bolt, so this may save you hours of troubleshooting.
Regular maintenance is one of the most overlooked ways to keep your laser producing clean, accurate engravings—and this is one of those fixes that’s inexpensive but can make a huge difference.
👇 Have you ever noticed your engraving quality slowly getting worse? What ended up being the cause?
Check out OneLaser machines here:
1laser.com/beardedbuilds
Discount code- BEARDEDBUILDS
#LaserEngraving #OneLaser #OneLaserXRF #OneLaserXT #ThunderBolt #ThunderLaser #LightBurn #LaserMaintenance #CO2Laser #SmallBusiness #Maker #LaserBusiness #DIY
