Uploaded October 2015 | Updated November 2026, 28 minutes ago
J. Carius, "Dynamic Maneuvers with a Single Wheel Robot", Bachelor Thesis, ETH Zurich, 2014. Supervised by P. Fankhauser, M. Hutter.
Report available at: http://students.asl.ethz.ch/upl_pdf/535-report.pdf
This work documents the development of a single wheel rolling robot prototype with a novel way of actuation. Formerly, such robots typically used two or more actuation methods such as mass displacement, reaction wheels or control moment gyroscopes. Contrary to that, we use only a single form of internal mass shifting. We decide to realize the moving masses in the form of pendulum arms that are suspended on either side of the wheel and can rotate around the wheel’s axis. The goal of this project is to demonstrate that both driving and jumping is possible with this simple form of actuation. The main focus is thereby placed on the jumping ability. We successfully show that our design is capable of jumping approximately 10 cm high and driving forward and backward with the proposed form of actuation. This report presents the conceptual elaboration of the system, shows simulation results and the implementation of the actual prototype. To limit the scope of this work, we restrict ourselves to the planar case and mount the prototype inside a test stand to constrain motion to a smaller number of degrees of freedom. The overall concept appears promising for further developments where a fully 3D approach can be taken.
J. Carius, "Dynamic Maneuvers with a Single Wheel Robot", Bachelor Thesis, ETH Zurich, 2014. Supervised by P. Fankhauser, M. Hutter.
Report available at: http://students.asl.ethz.ch/upl_pdf/535-report.pdf
This work documents the development of a single wheel rolling robot prototype with a novel way of actuation. Formerly, such robots typically used two or more actuation methods such as mass displacement, reaction wheels or control moment gyroscopes. Contrary to that, we use only a single form of internal mass shifting. We decide to realize the moving masses in the form of pendulum arms that are suspended on either side of the wheel and can rotate around the wheel’s axis. The goal of this project is to demonstrate that both driving and jumping is possible with this simple form of actuation. The main focus is thereby placed on the jumping ability. We successfully show that our design is capable of jumping approximately 10 cm high and driving forward and backward with the proposed form of actuation. This report presents the conceptual elaboration of the system, shows simulation results and the implementation of the actual prototype. To limit the scope of this work, we restrict ourselves to the planar case and mount the prototype inside a test stand to constrain motion to a smaller number of degrees of freedom. The overall concept appears promising for further developments where a fully 3D approach can be taken.










