Uploaded December 2020 | Updated November 2026, 28 minutes ago
By Silvan Fuhrer, Sebastian Verling, Thomas Stastny, and Roland Siegwart
Abstract -- Compared to other vertical take-off and landing (VTOL) systems, a tailsitter minimizes the number of actuators and moving parts necessary. The downside of having a minimalistic actuation is its inherent low fault-tolerance. The failure of an actuator usually results in a loss of controllability, resulting in a crash. In this paper we analyze possible actuator failures and the constraints they pose on the capabilities of the system. We further present light-weight adaptations to the nominal flight controller to make it fault-tolerant. The fault-tolerant controller is implemented on a small tailsitter VTOL aircraft and adjusted to the system by means of extensive experimental studies. Finally, the capabilities and performance under failures are demonstrated and analyzed.
This work was published in the 2019 International Conference on Robotics and Automation (ICRA).
Paper: ieeexplore.ieee.org/document/8793467
By Silvan Fuhrer, Sebastian Verling, Thomas Stastny, and Roland Siegwart
Abstract -- Compared to other vertical take-off and landing (VTOL) systems, a tailsitter minimizes the number of actuators and moving parts necessary. The downside of having a minimalistic actuation is its inherent low fault-tolerance. The failure of an actuator usually results in a loss of controllability, resulting in a crash. In this paper we analyze possible actuator failures and the constraints they pose on the capabilities of the system. We further present light-weight adaptations to the nominal flight controller to make it fault-tolerant. The fault-tolerant controller is implemented on a small tailsitter VTOL aircraft and adjusted to the system by means of extensive experimental studies. Finally, the capabilities and performance under failures are demonstrated and analyzed.
This work was published in the 2019 International Conference on Robotics and Automation (ICRA).
Paper: ieeexplore.ieee.org/document/8793467










![[T-RO 2026] Allocation for Omnidirectional Aerial Robots: Incorporating Power Dynamics
This is the accompanying video of our T-RO 2026 paper Allocation for Omnidirectional Aerial Robots: Incorporating Power Dynamics.
Paper: https://arxiv.org/abs/2412.16107
Abstract:
Tilt-rotor aerial robots are more dynamic and versatile than fixed-rotor platforms, since the thrust vector and body orientation are decoupled. However, the coordination of servos and propellers (the allocation problem) is not trivial, especially accounting for overactuation and actuator dynamics. We incrementally build and present three novel allocation methods for tilt-rotor aerial robots, comparing them to state-of-the-art methods on a real system performing dynamic maneuvers. We extend the state-of-the-art geometric allocation into a differential allocation, which uses the platform’s redundancy and does not suffer from singularities. We expand it by incorporating actuator dynamics and propeller power dynamics. These allow us to model dynamic propeller acceleration limits, bringing two main advantages: balancing propeller speed without the need for nullspace goals and allowing the platform to selectively turn off propellers during flight, opening the door to new manipulation possibilities. We also use actuator dynamics and limits to normalize the allocation problem, making it easier to tune and allowing it to track 70% faster trajectories than a geometric allocation. [T-RO 2026] Allocation for Omnidirectional Aerial Robots: Incorporating Power Dynamics](https://i.ytimg.com/vi/ybT80MyB9_Y/mqdefault.jpg)