Uploaded February 2019 | Updated September 2026, 1 week ago

---

An update to the Jarvie Arete supercar project, where we test fit some suspension pieces and powder coat the ECU case. Our wheel bearing, Corvette rotor and Porsche 911 brake calipers are test fit to the 3D printed hub (upright) before we move forward with molding and casting the part. I run into some problems with powder coating the Megasquirt Ms3x ECU case. The Prismatic Powders Intense blue is a bit finicky, but we learn a few new things about powder coating in this video as well. Lastly, a link at the end of the video shows the completed urethane roto-cast architectural spire from the silicone mold made in a previous video.

Architectural spire mold making video- youtu.be/l1nppsRhD04
Urethane roto-casting process video- youtu.be/uuvFowYOchU

#BuilderCreator #AreteGT #Supercar #DIY #CarBuild