Icom IC-7610 LAN setup up for RS-BA1 remote software. @waynephillips1848
Icom IC-7610 LAN setup up for RS-BA1 remote software.  @waynephillips1848
Uploaded June 2018 | Updated November 2026, 3 days ago
Very basic guide to set up you IC7610 as server and connect via LAN from any PC within the network, this was done in one take, bit rough but hopefully, should make things a little easier to set up.
1. Connect ic7610 to your LAN via the rear Ethernet connector.
2.Radio Menu, turn Networking On, check setting, Find you Radio IP address
3. Install RS-BA1 software and USB drivers.
4. Watch video

73s M0WPS
Icom IC-7610 LAN setup up for RS-BA1 remote software.Yaesu FT-897D PTT Mod, ACC Jack Socket for Amplfier, Microset SR-300TIDRADIO TD-H3 Plus, unboxing, Firmware update, TX levels, Squelch sensitivity, Spectrum analyserWAVETEK Schlumberger Stabilock SI 4031 RF Attenuator fault and FixNanoVNA-F V2 Vs original NanoVNA, overview and Test of Diamond X510Alinco DX70TH working with auto tuner MFJ 939CNC router millennium AXYZKenwood TS-870, Fix RX/TX fault on ANT2Icom IC-9700 TX Mod for 2M and 70cmFix Sharp Aquos TV  Faulty, switchs off after LogoSharp VZ-2500E Boombox Dismantle Front casing, speaker and grill removalHonda XL500s 1980, 6v electrics, Fit indicators and flasher relay
Waynes Share the Knowledge |

Icom IC-7610 LAN setup up for RS-BA1 remote software.

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER