Uploaded August 2021 | Updated September 2026, 1 hour ago

---

In this video, I make an Industrial Design Coat Hook, using a rebar rod to give it the real industrial decor look. It was a good welding project for me. I did not heat the steel for bending. I just used bits of pipe that slid over the rebar to get the leverage for the bend.

The steel plate is 3mm thick, 105mm long, and 42mm wide.
The Rebar is a 13mm rebar
Main tools used: Welding Magnets, V-Pads, MIG welder, angle grinder, Hammer, and a Drill.

The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au

►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark

Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.

Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY