Uploaded December 2025 | Updated September 2026, 2 weeks ago

---

youtube.com/watch?v=fFHO51KcX-g

laptopscreen.com
laptopscreen.com/English/brand/Lenovo

This is a guide on replacing a screen on Lenovo ThinkPad P1

For the replacement process we will need the following tools:
Plastic pick and tweezers.

To begin turn off the laptop and disconnect the power cord.

Now we can remove the bezel. Insert a plastic pick between the bezel
and the screen. Move it along the inner edge while unsnapping the tabs
underneath.

The screen is held in place with two adhesive strips with two loose tabs
in the top corners. Using tweezers pick the tab in the right top corner
and pull out adhesive strip. Pull out the adhesive strip from the other
side of the screen.

Place the screen on the keyboard. The video cable is attached to the back
cover with a small piece of tape. Using plastic pick peel off the tape.
Peel off another piece of tape securing the video connector. Using plastic
pick open the connector's bracket. Disconnect the video cable.
Discard the old screen.

Place the new screen on the keyboard. Reconnect the video cable, close
the connector's bracket. Secure it with a clear tape. Now we can test the
screen. Lift the screen up and turn on the laptop. The screen is working
and we can finish the installation process.

Place the screen back on the keyboard. We are going to use a new set of
adhesive strips which you can buy on our site: laptopscreen.com
Apply two adhesive strips on both side of the screen.

Lift the screen up. Using microfiber cloth rub firmly to catch the adhesive.
Make sure the video cable is tightly fit under the screen.

Replace the bezel. Press firmly in the bottom corners then go along the
perimeter snapping bezel in place. Close the laptop and make sure that bezel
is snapped near the hinges.

Turn the laptop on. And we are done!