Uploaded September 2015 | Updated November 2026, 12 hours ago
Gear & Studio Setup List: vonmalegowski.blogspot.com/2020/06/von-malegowskis-equipment-list-2020.html
This quick life hack tutorial demonstrates three simple, effective techniques to stop wired earphones and headphones from tangling into knots when stored in your pocket, backpack, or desk drawer. Spontaneous knotting is a mechanical certainty when loose, flexible cables undergo movement; by eliminating excess slack and locking the terminal ends, you can prevent internal wire crossover and pull out clean, tangle-free earbuds every single time.
Cable Management Methods Shown
The Wine Cork Spool: Carve a small notch in the top of a recycled wine cork to seat the headphone jack, wrap the cord neatly around the cylindrical body, and anchor the earbuds into a second notch at the base.
The Fold & Band Wrap: Coil or fold the cable into a tight figure-eight or flat bundle, securing the center firmly with an elastic rubber band or reusable twist tie.
The Self-Locking No-Tool Wrap: A standalone wrap technique (similar to the "devil horns" or figure-eight wrap) that uses the working end of the headphone cord itself to lock the bundle in place—no clips, ties, or extra hardware required.
Cable Longevity & Care
Avoid winding thin earphone cables tightly around your fingers or hard edges, as sharp bends fatigue the delicate copper wiring inside and break the connection at the audio plug strain relief.
Leave a little slack near the 3.5 mm jack and the earbud stems to prevent premature wire fraying.
The Physics of Tangling
Scientific Study & Breakdown: blogs.discovermagazine.com/seriouslyscience/2014/06/18/scientific-explanation-earphones-always-tangled/#.VgS5TN9VhBd
Music: YouTube Audio Library
Far Away — MK2
Please Tell Me — Silent Partner
Radio Rock — Audionautix
Licensed under Creative Commons Attribution 4.0 International: creativecommons.org/licenses/by/4.0 | Artist: audionautix.com
#LifeHacks #CableManagement #TechHacks
©Von Malegowski. All Rights Reserved.
Gear & Studio Setup List: vonmalegowski.blogspot.com/2020/06/von-malegowskis-equipment-list-2020.html
This quick life hack tutorial demonstrates three simple, effective techniques to stop wired earphones and headphones from tangling into knots when stored in your pocket, backpack, or desk drawer. Spontaneous knotting is a mechanical certainty when loose, flexible cables undergo movement; by eliminating excess slack and locking the terminal ends, you can prevent internal wire crossover and pull out clean, tangle-free earbuds every single time.
Cable Management Methods Shown
The Wine Cork Spool: Carve a small notch in the top of a recycled wine cork to seat the headphone jack, wrap the cord neatly around the cylindrical body, and anchor the earbuds into a second notch at the base.
The Fold & Band Wrap: Coil or fold the cable into a tight figure-eight or flat bundle, securing the center firmly with an elastic rubber band or reusable twist tie.
The Self-Locking No-Tool Wrap: A standalone wrap technique (similar to the "devil horns" or figure-eight wrap) that uses the working end of the headphone cord itself to lock the bundle in place—no clips, ties, or extra hardware required.
Cable Longevity & Care
Avoid winding thin earphone cables tightly around your fingers or hard edges, as sharp bends fatigue the delicate copper wiring inside and break the connection at the audio plug strain relief.
Leave a little slack near the 3.5 mm jack and the earbud stems to prevent premature wire fraying.
The Physics of Tangling
Scientific Study & Breakdown: blogs.discovermagazine.com/seriouslyscience/2014/06/18/scientific-explanation-earphones-always-tangled/#.VgS5TN9VhBd
Music: YouTube Audio Library
Far Away — MK2
Please Tell Me — Silent Partner
Radio Rock — Audionautix
Licensed under Creative Commons Attribution 4.0 International: creativecommons.org/licenses/by/4.0 | Artist: audionautix.com
#LifeHacks #CableManagement #TechHacks
©Von Malegowski. All Rights Reserved.










