Uploaded May 2016 | Updated November 2026, 18 hours ago
Gear & Studio Setup List: vonmalegowski.blogspot.com/2020/06/von-malegowskis-equipment-list-2020.html
This quick DIY project shows how to build a compact, circular pocket slingshot in just a few minutes using common household recyclables. By mounting the elastic body of a latex balloon over the threaded neck of a plastic beverage bottle (or a short section of PVC pipe), you create a high-velocity circular launcher. It shoots smooth projectiles such as airsoft BBs, small marbles, or dried peas, fits completely inside a pocket, and allows the balloon pouch to be swapped out in seconds if worn down.
Materials & Tools Needed
Disposable plastic bottle (rigid threaded spout) or short 1" to 1.5" PVC pipe ring
Heavy-duty latex balloon
Duct tape or heavy electrical tape
Utility knife or sharp scissors
How to Make a Pocket Slingshot
1. Using a utility knife, carefully cut the top spout off a plastic bottle roughly 1.5 inches below the threaded rim.
2. Trim the narrow neck stem off the balloon, keeping the wide lower elastic bulb.
3. Stretch the trimmed opening of the balloon completely over the threaded bottle mouth until it sits snug against the rim.
4. Wrap electrical or duct tape tightly around the base of the balloon over the plastic ring to lock the elastic firmly in place under high draw tension.
5. To fire, drop a smooth projectile into the mouth of the bottle so it rests in the bottom pocket of the balloon. Pinch the projectile through the rubber, pull back firmly, align your target through the ring opening, and release.
Safety & Handling Warnings
Never point or fire a slingshot at people, pets, or fragile property. Use only smooth, rounded ammunition—sharp pebbles or jagged stones will puncture the latex wall under tension and cause the band to snap back into your hand or face. Always wear protective eye goggles during assembly and shooting.
Slingshot Mechanics & Background
Traditional slingshots (or bean shooters) rely on a rigid Y-shaped fork to anchor two opposing flat or tubular elastic bands. A circular pocket slingshot replaces the traditional fork with a rigid ring guide, concentrating draw force evenly around the perimeter of the latex bulb for a compact, center-fire launch.
Music: YouTube Audio Library
Tracks: Reasons_to_Smile — Topher Mohr and Alex Elena | Sunday_Plans — Silent Partner
Licensed under Creative Commons Attribution 3.0: creativecommons.org/licenses/by/3.0
#DIYWeapons #Slingshot #PocketSlingshot #SurvivalHacks
©Von Malegowski. All Rights Reserved.
Gear & Studio Setup List: vonmalegowski.blogspot.com/2020/06/von-malegowskis-equipment-list-2020.html
This quick DIY project shows how to build a compact, circular pocket slingshot in just a few minutes using common household recyclables. By mounting the elastic body of a latex balloon over the threaded neck of a plastic beverage bottle (or a short section of PVC pipe), you create a high-velocity circular launcher. It shoots smooth projectiles such as airsoft BBs, small marbles, or dried peas, fits completely inside a pocket, and allows the balloon pouch to be swapped out in seconds if worn down.
Materials & Tools Needed
Disposable plastic bottle (rigid threaded spout) or short 1" to 1.5" PVC pipe ring
Heavy-duty latex balloon
Duct tape or heavy electrical tape
Utility knife or sharp scissors
How to Make a Pocket Slingshot
1. Using a utility knife, carefully cut the top spout off a plastic bottle roughly 1.5 inches below the threaded rim.
2. Trim the narrow neck stem off the balloon, keeping the wide lower elastic bulb.
3. Stretch the trimmed opening of the balloon completely over the threaded bottle mouth until it sits snug against the rim.
4. Wrap electrical or duct tape tightly around the base of the balloon over the plastic ring to lock the elastic firmly in place under high draw tension.
5. To fire, drop a smooth projectile into the mouth of the bottle so it rests in the bottom pocket of the balloon. Pinch the projectile through the rubber, pull back firmly, align your target through the ring opening, and release.
Safety & Handling Warnings
Never point or fire a slingshot at people, pets, or fragile property. Use only smooth, rounded ammunition—sharp pebbles or jagged stones will puncture the latex wall under tension and cause the band to snap back into your hand or face. Always wear protective eye goggles during assembly and shooting.
Slingshot Mechanics & Background
Traditional slingshots (or bean shooters) rely on a rigid Y-shaped fork to anchor two opposing flat or tubular elastic bands. A circular pocket slingshot replaces the traditional fork with a rigid ring guide, concentrating draw force evenly around the perimeter of the latex bulb for a compact, center-fire launch.
Music: YouTube Audio Library
Tracks: Reasons_to_Smile — Topher Mohr and Alex Elena | Sunday_Plans — Silent Partner
Licensed under Creative Commons Attribution 3.0: creativecommons.org/licenses/by/3.0
#DIYWeapons #Slingshot #PocketSlingshot #SurvivalHacks
©Von Malegowski. All Rights Reserved.










