How to Change The Oil and Filter In a Car @vonmalegowski
How to Change The Oil and Filter In a Car  @vonmalegowski
Uploaded September 2016 | Updated November 2026, 3 days ago
Gear & Studio Setup List: vonmalegowski.blogspot.com/2020/06/von-malegowskis-equipment-list-2020.html

This automotive maintenance tutorial demonstrates how to perform a complete DIY engine oil and filter change on a car. Regularly replacing degraded engine oil and a contaminated filter is one of the most straightforward and cost-effective ways to protect your engine and extend vehicle life. Before starting, consult your vehicle owner's manual (or dashboard maintenance indicator on newer models) to confirm your recommended service interval, exact oil viscosity grade, and sump capacity.

Tools & Supplies Needed

New engine oil (exact viscosity and capacity specified in your owner's manual)
Replacement oil filter and new drain plug crush washer/gasket
Car ramps or floor jack with rated jack stands, plus wheel chocks
Socket wrench set and oil filter wrench (if needed)
Oil drain pan and clean funnel
Shop rags, nitrile gloves, and safety glasses

Step-by-Step Oil & Filter Change Guide

1. Elevate & Secure the Vehicle: Drive the front wheels onto car ramps or lift the vehicle with a jack and secure it firmly on rated jack stands. Engage the parking brake and place wheel chocks behind the rear tires to prevent any movement.

2. Locate & Loosen the Drain Plug: Slide your oil drain pan directly beneath the engine oil pan drain plug (refer to your service manual if unsure of its exact location) and break the plug loose using a socket wrench.

3. Drain the Old Oil: Unscrew the drain plug the rest of the way by hand and allow the used oil to empty completely into the drain pan. Remove the oil filler cap on top of the engine to relieve vacuum pressure and help the oil drain faster.

4. Reinstall the Drain Plug: Once the oil slows to a drip, wipe the drain area clean, fit a new drain plug gasket if applicable, and thread the plug back in by hand to prevent cross-threading. Snug it securely with your wrench without over-tightening.

5. Remove the Old Oil Filter: Reposition the drain pan underneath the oil filter, unscrew the old filter, and let residual oil drain. Wipe the engine's filter mounting surface clean with a shop rag and verify that the old rubber O-ring gasket came off with the filter and is not stuck to the engine block.

6. Install the New Oil Filter: Coat the rubber gasket of the new filter with a thin film of fresh motor oil, verify the seal is seated properly, and spin the new filter onto the engine by hand until snug (avoid over-tightening with a wrench).

7. Refill with Fresh Oil: Place a clean funnel into the engine oil filler neck and pour in the specified grade and quantity of fresh oil, holding back slightly at first in case a small amount of old oil remained in the system. Reinstall the oil filler cap.

8. Run Engine & Inspect for Leaks: Start the engine and let it idle for a few minutes while checking underneath around the drain plug and oil filter for any drips. If any leaks appear, shut off the engine immediately and address them; otherwise, turn off the engine and wait about 5 minutes for the oil to settle back into the pan.

9. Verify Oil Level & Lower Vehicle: Pull out the dipstick, wipe it clean, reinsert it fully, and withdraw it again to check the reading. Top off gradually until the oil sits cleanly at the full mark, then remove the wheel chocks and carefully back off the ramps (or lower off jack stands).

10. Recycle Used Oil & Filter: Transfer the waste oil into sealed containers and take both the used oil and old filter to an authorized auto parts store, municipal eco-station, or recycling center for proper disposal.

Automotive Safety Disclaimer
Never get underneath a vehicle supported solely by a hydraulic or scissor jack. Always use rated jack stands or solid wheel ramps on a flat, level surface, chock the wheels, and allow hot engine oil to cool slightly before draining to avoid burns.

Music: YouTube Audio Library
Tracks: Fun — Vibe Tracks | Eyes_On_You — Network 415

#OilChange #CarMaintenance #MechanicTip
©Von Malegowski. All Rights Reserved.
How to Change The Oil and Filter In a CarDIY String Ball Ornaments | Christmas OrnamentsHow to Make a Paper BoatHow to Make Iron Oxide (Rust) PowderHow to Make a Paper CubeHow to Pack Clothes for Traveling 👕💼How to Make Tempura ShrimpHow to Make Paper Lucky StarsHow to Open Canned Food With a Spoon 🥫🥄How to Make Pepper SprayHow to Make a Simple Lock ShimHow to Make a Candle from an Orange 🍊🕯️
Von Malegowski |

How to Change The Oil and Filter In a Car

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER