Uploaded October 2026 | Updated November 2026, 8 hours ago
I messed this up.
It happens from time to time, you get complacent and don’t check everything properly, in this instance, I used a prop to fire this vase upon that had previously been smothered in molten iron that had run off of another vessel. At some point I’d obviously tried to resolve it by chipping away the fluxed metal and painting over it with batt-wash, but as those of you who’ve experienced this will know, molten iron like this that liquifies can imbed into the props, making it almost impossible to remove.
This means that when this vase was fired atop the raiser, the iron bubbled up again and essentially glued the pot in place, not that I realised of course when it came to plucking it out from the kiln. I heard it tear in that instance, it sort of ripped away and low and behold, a sizeable fragment had been pulled away, ruining an otherwise lovely, dark green angular vase.
So, in this quick video I’m going to show you how I go about fixing such an error as best I can. It takes a bit of time, especially when attempting to keep the shape true so that the new addition follows the same curvature of the foot-ring itself.
Sorry for all the harsh noises. I wear headphones when doing this for a reason.
#fail #beforeandafter #oddlysatisfiyng #craft #pottery
I messed this up.
It happens from time to time, you get complacent and don’t check everything properly, in this instance, I used a prop to fire this vase upon that had previously been smothered in molten iron that had run off of another vessel. At some point I’d obviously tried to resolve it by chipping away the fluxed metal and painting over it with batt-wash, but as those of you who’ve experienced this will know, molten iron like this that liquifies can imbed into the props, making it almost impossible to remove.
This means that when this vase was fired atop the raiser, the iron bubbled up again and essentially glued the pot in place, not that I realised of course when it came to plucking it out from the kiln. I heard it tear in that instance, it sort of ripped away and low and behold, a sizeable fragment had been pulled away, ruining an otherwise lovely, dark green angular vase.
So, in this quick video I’m going to show you how I go about fixing such an error as best I can. It takes a bit of time, especially when attempting to keep the shape true so that the new addition follows the same curvature of the foot-ring itself.
Sorry for all the harsh noises. I wear headphones when doing this for a reason.
#fail #beforeandafter #oddlysatisfiyng #craft #pottery










