Uploaded June 2026 | Updated September 2026, 2 weeks ago

---

If your NETGEAR router or modem is acting up, a factory reset can often fix problems like slow Wi Fi, connection drops, forgotten passwords, or setup issues. This guide shows how to reset almost any NETGEAR router, modem/router combo, Nighthawk, Orbi, or cable modem back to its original factory settings.
How to Factory Reset a NETGEAR Router or Modem
Keep the device powered on.
Locate the small RESET hole on the back or bottom of the device.
Press and hold the RESET button for 10–15 seconds using a paperclip or SIM tool.
Wait for the LEDs to blink and the device to reboot.
Allow 2–5 minutes for the reset to finish.
What Happens After a Factory Reset?
The device returns to its default factory settings.
You will need to:
Reconnect to the default Wi‑Fi network (SSID)
Use the default password printed on the label
Set up your internet connection again if required
Recreate any custom Wi‑Fi names, passwords, parental controls, or port forwarding rules
Default Login Information
Setting
Common Default
Router login
routerlogin.net
IP address
192.168.1.1
Username
admin
Password
password
Applies to Most NETGEAR Models
NETGEAR Nighthawk

NETGEAR Orbi

NETGEAR Wi‑Fi Routers

NETGEAR Cable Modems

NETGEAR Modem/Router Combos

NETGEAR Mesh Systems

If the Reset Doesn’t Work

Make sure the device is powered on.

Hold the button for the full 15 seconds.

Try a paperclip instead of a pen.

Wait at least 5 minutes after the reboot. #netgear #wifirouter

Disclaimer: As an Amazon Associate I earn from qualified purchases.