How I Get Oramask to Stick So Well @ToolsToday
How I Get Oramask to Stick So Well  @ToolsToday
Uploaded November 2026 | Updated November 2026, 3 hours ago
Ever wondered how we get Oramask 813 to stick so well when V-carving through it?
One of the biggest things I've found is that proper surface preparation makes all the difference. I start by sanding the wood to 180 grit, then blow off the sawdust and go back over the surface by hand to remove anything that's left behind. Once the surface is clean, I use a plastic spreader to apply the masking, pressing it firmly into the wood while working out any air bubbles. I also trim away any excess masking along the edges to keep it from catching on anything and lifting. It's a simple process, but it's worked really well for us when carving through masking!
Check out the tools used on our website
--
Oracal Oramask 813 Stencil Film, item no. ORA813
toolstoday.com/oracal-oramask-813-stencil-film-12-inch-wide-x-20-foot-long-roll.html
Yellow 4" Plastic Spreader, item no. 4526
toolstoday.com/yellow-4-plastic-spreader-pack-of-5.html
Festool ETS EC 125/3 EQ-Plus Random Orbital Sander, item no. FS-576340
toolstoday.com/festool-576340-random-orbital-sander-ets-ec-125-3-eq-plus.html
How I Get Oramask to Stick So WellUnboxing the New Powermatic PM15BHH PlanerLaser Engraving Logos on AcrylicCarving a Perfectly Clean SignPerfectly Square Every TimeCutting an Aluminum Letter on the CNCInstantly Switch from Router Table to Handheld RouterThis Sword is Actually a SquareCarving a Halloween SignUsing a Magnetic Vise to Reinforce a Heavy Wheel DollyCurved Edge BandingNo Fogging and No Dust with Trend AirShield Pro
ToolsToday |

How I Get Oramask to Stick So Well

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER