Laser Engraving Logos on Acrylic @ToolsToday
Laser Engraving Logos on Acrylic  @ToolsToday
Uploaded September 2026 | Updated November 2026, 3 hours ago
Engraving the logos into our custom acrylic router base using the xTool P2S laser!
Yesterday we cut a 1/4" plywood template to hold the CNC cut acrylic base in the correct position. Now we're using that template to keep everything aligned while engraving the logos directly into the acrylic.
 
Engraving Settings-
Power: 20%
Speed: 400mm/s
Lines per cm: 200

#shorts #short
Laser Engraving Logos on AcrylicCarving a Perfectly Clean SignPerfectly Square Every TimeCutting an Aluminum Letter on the CNCInstantly Switch from Router Table to Handheld RouterThis Sword is Actually a SquareCarving a Halloween SignUsing a Magnetic Vise to Reinforce a Heavy Wheel DollyCurved Edge BandingNo Fogging and No Dust with Trend AirShield ProFixing My Router MistakeFlush Trimming a Letter
ToolsToday |

Laser Engraving Logos on Acrylic

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER