Uploaded July 2026 | Updated November 2026, 6 hours ago
We take a look at the Invasive Liquid Flow demo kit from Honeywell. It comes fully calibrated and with a USB-C interface for plug and play high resolution liquid flow measurements for medical applications.
Inside the box, you’ll find a reusable base station, two disposable liquid flow cartridges, silicone tubing, tubing connectors, a zip tie, a t-slot frame mounting screw and a USB-C cable.
In this demo we’re going to set up the sensor and measure water flow using the demo software. This will be gravity-fed, but you can also connect a pump like you would use for dialysis, infusion, or other medical applications, as the thermopile flow sensor can measure flow rates from 0 to 400 milliliters per hour.
Mount the base station. It can be mounted many ways, but we’ll be using a clamp. Note the flow direction on the sensor and plug it into the base station, then cut the tubing to the appropriate lengths and connect it to both sides of the sensor. We’re connecting the top side to a cup that we’ll fill with water and the bottom side goes into a cup to collect the water. Plug the USB cable in between the base station and your computer.
Open the liquid flow demo application. Click connect if it doesn’t auto-connect to your sensor, then click start new test, enter a filename, and measurements will start. Now if I lift my cup up to start the flow of water, we can see both the instantaneous and rolling average flow values pin the graph and listed in the top right. You can also change your sampling rate and rolling average settings to suit your application.
digikey.com/en/products/detail/honeywell-sensing-and-productivity-solutions/ILFE00400/25821924
Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey
We take a look at the Invasive Liquid Flow demo kit from Honeywell. It comes fully calibrated and with a USB-C interface for plug and play high resolution liquid flow measurements for medical applications.
Inside the box, you’ll find a reusable base station, two disposable liquid flow cartridges, silicone tubing, tubing connectors, a zip tie, a t-slot frame mounting screw and a USB-C cable.
In this demo we’re going to set up the sensor and measure water flow using the demo software. This will be gravity-fed, but you can also connect a pump like you would use for dialysis, infusion, or other medical applications, as the thermopile flow sensor can measure flow rates from 0 to 400 milliliters per hour.
Mount the base station. It can be mounted many ways, but we’ll be using a clamp. Note the flow direction on the sensor and plug it into the base station, then cut the tubing to the appropriate lengths and connect it to both sides of the sensor. We’re connecting the top side to a cup that we’ll fill with water and the bottom side goes into a cup to collect the water. Plug the USB cable in between the base station and your computer.
Open the liquid flow demo application. Click connect if it doesn’t auto-connect to your sensor, then click start new test, enter a filename, and measurements will start. Now if I lift my cup up to start the flow of water, we can see both the instantaneous and rolling average flow values pin the graph and listed in the top right. You can also change your sampling rate and rolling average settings to suit your application.
digikey.com/en/products/detail/honeywell-sensing-and-productivity-solutions/ILFE00400/25821924
Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey










