Holding Small CNC Parts Without Tabs or Clamps @ToolsToday
Holding Small CNC Parts Without Tabs or Clamps  @ToolsToday
Uploaded August 2026 | Updated November 2026, 1 day ago
Painter’s tape and CA glue is one of my favorite ways to hold material down when I need to make full profile cuts on small parts without having to use tabs.

Painter’s tape goes on the CNC bed and the workpiece, then a little Starbond Medium CA glue and accelerator between the two. It creates a surprisingly strong hold across the entire part, but still makes cleanup easy when the cut is finished.

I gave this piece of acrylic a pretty good pull at the end and the CNC moved before the material did!

Simple, secure, and especially useful for small parts and through cuts where traditional clamps or tabs aren’t ideal. Check out the tools used available on our website -

Starbond Medium CA Glue, item no. 1502 - toolstoday.com/starbond-multi-purpose-medium-ca-glue-em-150-2-ounce.html

Starbond Accelerator, item no. A6 - toolstoday.com/starbond-aerosol-accelerator-6-ounce.html

Painters Tape, item no. 3M-2090-48NC - toolstoday.com/3m-2090-48nc-scotchblue-original-multi-surface-painters-tape-48mm-x-60-yards
Holding Small CNC Parts Without Tabs or ClampsRouting a Perfect Pocket With a Variable Router JigCutting out Weather Proof Garden SignCold Cutting Steel With a Cordless Circular SawThis CNC Changes Its Own ToolsNo Sanding Needed Finish on CNC TrayThis CNC Pumpkin Reveal Is So SatisfyingSpeed Cutting Cabinet PartsCarving and Filling NameSpray Gun Cleanup Isn’t the Problem… You’re Doing It WrongA Budget Friendly Way to Break Down PlywoodUnboxing Jet Smart Drill Press
ToolsToday |

Holding Small CNC Parts Without Tabs or Clamps

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER