High Voltage Wood Burning @BillGilmour519
High Voltage Wood Burning  @BillGilmour519
Uploaded August 2015 | Updated November 2026, 3 hours ago
I wanted to try some high voltage woodburning. As a power supply, I chose the two MOT supply normally used for charging my capacitor bank. It can supply AC or DC. Some old spruce fence boards were cut up into short lengths of about a foot or so. One HV lead was connected to a screw in the wood near one end. The other HV lead was connected to my chicken stick to allow me to move the contact point. I started with water, brushing it on to the face of the board before applying the HV. Also used were vinegar, hydrochloric acid, and sodium hydroxide solution. One maple board was tried and it gave the best result. This experiment burned a lot of wood but some interesting patterns resulted. I ran a disk sander over the pieces to clean them up and all of them are shown at the end of the video.
High Voltage Wood BurningA Century Old Nail Puller ToolDry Ice Bottle BombCasting More Aluminium Skull Heads And A Failed HandDisposal Of A Halloween PumpkinThermite On A Dead LaptopHome Made .25 Cal BB GunAir Cannon #126 - Dead PC Power SupplySlow Motion - Water Balloon On GravelHydraulic Squash #1Capacitor Bank #80 - Blowing Stuff UpSodium Silicate (Water Glass) From Silica Gel
Bill Gilmour |

High Voltage Wood Burning

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER