Hendey Lathe Spindle Removal & D1-6 Camlock Repair @MikefromMissouri

Hendey Lathe Spindle Removal & D1-6 Camlock Repair @MikefromMissouri

Uploaded January 2021 | Updated September 2026, 13 hours ago

Figured out how to remove the spindle on a Hendey and repaired the Camlock holes.

Hendey Lathe Spindle Removal & D1-6 Camlock Repair

Cummins 4B Engine Removal from Case 1840 - The Hardest Way Possible

Hendey Lathe Brief Update

Contact Wheel Accessory 2x72 Grinder

Finishing the DIY Sand Blaster & First Test

Atlas Copco Throttle Problem - Deutz Diesel Powered Air Compressor Repair

Ford 3000 Front Axle Upgrade

$Forge Up to Temp & First Time Blacksmith After several heat cycles to cure the refractory I was finally able to bring it to full temp today. Also hit on some hot metal.$

Torch Set Upgrade & a Gift from Area Diesel Service

Hendey Lathe Quick Change Gearbox re-assembly (Part 1)

Working the Case 1840 Hard Cause TWO Failures after Restoration

Case 1840 - Frame Cracks, Repairs & Stiffener Plate Upgrade - Flushing the Hydraulic Tank

Mike From Missouri |

Hendey Lathe Spindle Removal & D1-6 Camlock Repair