Contact Wheel Accessory 2x72 Grinder @MikefromMissouri

Uploaded January 2021 | Updated September 2026, 4 hours ago

In this video I adapt an 8” contact wheel that I purchased on eBay for $50 to Brian Housewert’s designed 2x72 grinder that I built a few months back. This add on is worth every penny! Search Brian Housewert for plans to this grinder.

Finishing the DIY Sand Blaster & First Test

Atlas Copco Throttle Problem - Deutz Diesel Powered Air Compressor Repair

$Forge Up to Temp & First Time Blacksmith After several heat cycles to cure the refractory I was finally able to bring it to full temp today. Also hit on some hot metal.$

Torch Set Upgrade & a Gift from Area Diesel Service

Hendey Lathe Quick Change Gearbox re-assembly (Part 1)

Working the Case 1840 Hard Cause TWO Failures after Restoration

Case 1840 - Frame Cracks, Repairs & Stiffener Plate Upgrade - Flushing the Hydraulic Tank

Paying Stupid Tax!! - Case 1840 Restoration Setback & Slow Progress

New Rubber for the Case 1840 - Camso SKS 753