Finishing the DIY Sand Blaster & First Test @MikefromMissouri

Finishing the DIY Sand Blaster & First Test @MikefromMissouri

Uploaded March 2024 | Updated September 2026, 3 hours ago

Finishing the final details on the sand blaster and testing it

Finishing the DIY Sand Blaster & First Test

Atlas Copco Throttle Problem - Deutz Diesel Powered Air Compressor Repair

Ford 3000 Front Axle Upgrade

$Forge Up to Temp & First Time Blacksmith After several heat cycles to cure the refractory I was finally able to bring it to full temp today. Also hit on some hot metal.$

Torch Set Upgrade & a Gift from Area Diesel Service

Hendey Lathe Quick Change Gearbox re-assembly (Part 1)

Working the Case 1840 Hard Cause TWO Failures after Restoration

Case 1840 - Frame Cracks, Repairs & Stiffener Plate Upgrade - Flushing the Hydraulic Tank

Paying Stupid Tax!! - Case 1840 Restoration Setback & Slow Progress

New Rubber for the Case 1840 - Camso SKS 753

Forge Build - Ribbon Burner - Part 1

Blacksmith Rookie Forges a Hammer Part 1

Mike From Missouri |

Finishing the DIY Sand Blaster & First Test