GMC Envoy intermittent no start Class 2 fault @ThePracticalMechanic
GMC Envoy intermittent no start Class 2 fault  @ThePracticalMechanic
Uploaded October 2022 | Updated November 2026, 3 hours ago
This GMC Envoy had an intermittent no start. Come along as we diagnose the no start. We quickly realize the data network is down since we cannot communicate with any modules. This vehicle uses GM Class 2 communication on a single wire.
By scoping the network on pin 2 of the data link connector we see that the network is getting shorted to power. This is causing the no start condition since the modules cannot confirm security information and starting requirements.
Many of these Class 2 vehicles have convenient network splice packs that allow us to isolate modules on the network without unplugging all the modules one at a time.

After working our way through 2 splice packs we isolate the liftgate module as the cause of the communication fault. Broken wires in the decklid harness caused lot of grief and a wild goose chase.

thanks for watching
GMC Envoy intermittent no start Class 2 faultLive 1996 Toyota 4runner Cylinder head installationMercedes o309 OM314 starting system electrical - series/parallel switchScope 101 for Dummies- A Guide to Using a Oscilloscope with the Launch Torque 5Biscayne Ep39 - 4l60e Driveshaft installProgramming a Lexus Smart Key with DG Technologies - VSI NXGen Plus J2534 and Toyota GTS+Live Diagnostics - Ford Ecoboost Misfire under loadWeekly waveform 2 recap and review. New accessories for next week.Ford 6 7l Injector IQA procedure using the Launch Diagun2005 Subaru Forester Pt 2 Engine removal2004 Chevrolet 2500HD 6.6 Duramax LB7 rough idle - case studyWeekly Waveform 21 - Testing Oxygen Sensor Signal and Heater Circuits
ThePracticalMechanic |

GMC Envoy intermittent no start Class 2 fault

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER