2005 Subaru Forester Pt 2 Engine removal @ThePracticalMechanic
2005 Subaru Forester Pt 2 Engine removal  @ThePracticalMechanic
Uploaded August 2020 | Updated November 2026, 3 hours ago
In the last episode we found out that my "new" Subaru has a broken timing belt and leaking head gaskets. I opted to just remover the engine and replace the head gasket. We will inspect the valves while the head are off.

In this episode we unhook everything from the top side of the engine and remove the engine from the car.

Up next will be removing the heads from the engine and performing a quick inspection before we head to the machine shop.
2005 Subaru Forester Pt 2 Engine removal2004 Chevrolet 2500HD 6.6 Duramax LB7 rough idle - case studyWeekly Waveform 21 - Testing Oxygen Sensor Signal and Heater CircuitswiTECH 2.0 - Will it work with Launch Smart link j2534 device?2008 Chevrolet Trailblazer P0449 Diagnostic and repairPolarity reversing switch for motor and actuator control - adding banana jacks LiveHow to Optimize Your Inventory by looking at Your Item Movement - NAPATracs Enterprise SMS2010 Ford stuck in low range quick Diag1997 Toyota Camry Denso Starter Contact failure with scope captures2014 Toyota RAV4 maintenance light reset with blade style ignition key.Weekly Waveform 5 - Invert, AC couple, ignition sync, relative compression2004 BMW 325i Fuel gauge doesnt work   PHAD Fix
ThePracticalMechanic |

2005 Subaru Forester Pt 2 Engine removal

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER